Is the anticorrosion treatment of cast iron gates necessary?
Is the anticorrosion treatment of cast iron gates necessary?
With the wide application of cast iron gates, a series of problems have also followed. Among them, the anti-corrosion problem of cast iron inlaid copper gates has attracted much attention from customers. Only the anti-corrosion and anti-rust work of the equipment can be realized. With regard to this issue, the Qianjin Hydraulic Engineering Department makes the following summary based on years of production and sales experience, and hope to help you:
The necessity of anti-corrosion treatment for cast iron gates:
Cast iron gates often have some defects or faults after long-term operation or use: the corrosion of the steel gate; the jamming of the gate operation (formed by the displacement of the gate leaf, the deformation of the gate leaf, and the falling of the walking support); the gate stops Water loss, severe water leakage; defects or faults of door leaf and embedded parts due to cavitation, corrosion, abrasion, etc. If these defects or faults are not dealt with and removed in real time, they will seriously affect the safe operation of the gate. Therefore, not only must pay attention to the task situation and carry out real-time protection and maintenance, but also repair the gates on schedule.
Specific methods for anti-corrosion of cast iron gates:
The metal parts of cast iron gates and steel structure gates should be treated with rust and corrosion protection on schedule. The commonly used anti-corrosion methods for steel gates are paint maintenance and metal spraying maintenance. Before protective treatment, it is necessary to carefully remove rust on the outside. Common methods include manual shoveling, wire brushing, and sandblasting to remove rust. It is required to remove old paint and rust, rust spots, oil, dust, acid and alkali, and salt residues, and then scrub with pine nasal spray or turpentine to make it all show off the gray-white metal nature, and insist on being dry and inevitably rough The final coating must have a certain thinner to make it reach a suitable consistency to facilitate the construction operation. Ordinary supporting thinner all year round. The anti-rust paint thinner should not be added too much, generally it is better not to exceed 2% to 3% of the weight of the paint. Zinc spraying is a useful way to maintain steel structure. It has a long life span, generally up to 20 years, but it is expensive and requires special equipment.
Related Industry Knowledge
- The difference between hoist and hydraulic screw hoist
- Classification methods and characteristics of gate hoist products in water conservancy machinery factory industry
- The general performance and how to manage the screw hoist
- What types of gates can be made into reservoir gates according to the width of the river channel and what are the precautions?
- The working principle and introduction of road machine door integrated gate
- Maintenance and maintenance of gate hoist
- How to prevent water leakage in the gate?
- What are the reasons for the water leakage of the gate?
- Where are the cast iron square gates used and what are the advantages?
- Where is the reservoir gate generally located on the water and what are the points of attention?
- Lubrication requirements for the copper sleeve of the connecting shaft of the winch hoist
- Lubrication of gate hoist is a very important job
- The mobile grab cleaning machine can be usefully applied to all types and various water intakes
- Which is better, cast iron gate and steel gate
- The scope of use and performance advantages of the grab-type dirt cleaner
- How to improve the efficiency and quality of hoist hoist
- How to save the cast iron gate from being corroded?
- Trouble and accident treatment of mechanical grille cleaning machine
- Professional steel gate production-gate manufacturer Xinertai
- The installation method of the cleaning machine should be trained and learned