How to install and adjust screw hoist
How to install and adjust screw hoist
Before installation, it is necessary to check whether the various parts are good, whether the grease is on the foot, whether the anchor bolts are loose, and whether the relevant technical statistics between the two are consistent.
1. Before installation, it is necessary to check whether the parts are good, whether the grease is on the foot, whether the anchor bolts are loose, and whether the relevant technical statistics between the two are consistent.
2. During installation, the level of the basic layout plan must be maintained at 180°; the total contact area between the gate hoist base and the basic layout plan must exceed about 90%; the centerline of the screw rod must vertically bisect the sea of the load-bearing beam on the gate platform. Plane: It must be vertical to the lug hole of the gate to prevent the screw rod from skewing, causing partial support and destroying the parts.
3. After installation, a trial run must be performed. Once a no-load test is performed, the screw rod is arranged for 2 strokes, and whether there is any abnormal noise, check whether the installation meets the technical standards. Second, make a load test. Under the rated load, make two stroke arrangements to observe the operating conditions of the screw rod and the sluice to see if there are any abnormalities. Once the accuracy is confirmed, the operation can be declared. After the load has been in operation for a period of time, the initial maintenance should be carried out. The metal material foam caused by the friction of the new parts of the fuselage is very screw, nut, pressurized, and worm. It should be cleaned and cleaned with lubricating grease and sealed. Sexually strict, apply again.
Related Industry Knowledge
- The difference between hoist and hydraulic screw hoist
- Classification methods and characteristics of gate hoist products in water conservancy machinery factory industry
- The general performance and how to manage the screw hoist
- What types of gates can be made into reservoir gates according to the width of the river channel and what are the precautions?
- The working principle and introduction of road machine door integrated gate
- Maintenance and maintenance of gate hoist
- How to prevent water leakage in the gate?
- What are the reasons for the water leakage of the gate?
- Where are the cast iron square gates used and what are the advantages?
- Where is the reservoir gate generally located on the water and what are the points of attention?
- The cleaning machine is an indispensable cleaning and slag treatment equipment in the water treatment process
- Attention to the installation of screw hydraulic hoist
- Discussion on the Application and Benefit of Rotary Cleaner
- Regulations for Trial Operation of Hydraulic Hoist
- The gate plays an important role in hydraulic engineering
- The structure and advantages of screw hoist
- The operation of gate hoist should pay attention to the following points
- The gate hoist test should meet these conditions
- Classification method of water conservancy hoist gate products in the water conservancy machinery factory industry
- Working principle and maintenance of steel gate